OIL PRESSURE SENSOR INSTALLATION
PROCEDURE
INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY
Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.
Adhesive
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
Note:Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.
Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.
15 N*m
153 kgf*cm
11 ft.*lbf
Note:Do not start the engine for at least 1 hour after installation.
Connect the oil pressure sender gauge assembly connector.
ADD ENGINE OIL
INSPECT FOR OIL LEAK
INSPECT ENGINE OIL LEVEL
INSTALL OIL FILTER ELEMENT SERVICE HOLE COVER