FUEL SUPPLY PUMP INSPECTION
PROCEDURE
INSPECT SUPPLY PUMP ASSEMBLY
Inspect the suction control valve assembly.
-
*a
Component without harness connected
(Suction Control Valve Assembly)
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
1.9 to 2.3 Ω
Tip:The temperature indicated in "Condition" is the temperature of the suction control valve assembly.
If the result is not as specified, replace the suction control valve assembly.
-
Inspect the fuel temperature sensor.
If the result is not as specified, replace the fuel temperature sensor.