CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM(for 8NR-FTS) Pattern Select Switch Sport Mode Circuit
| DTC Code | DTC Name |
|---|---|
| Pattern Select Switch Sport Mode Circuit |
DESCRIPTION
The ECM memory contains the programs for the normal and sport shift patterns.
By following the programs corresponding to the signals from the SPORT switch (combination switch assembly), the park/neutral position switch and other various sensors, the ECM switches the shift control solenoid valves on and off, and controls the transaxle gear ratio.
WIRING DIAGRAM
PROCEDURE
READ VALUE USING GTS (POWER MODE SW)
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List.
According to the display on the GTS, read the Data List.
Powertrain > Engine > Data List
Tester Display
Measurement Item
Range
Normal Condition
Diagnostic Note
Power Mode SW
SPORT switch (combination switch assembly) status
OFF or ON
ON: Switch being pushed
OFF: Switch not being pushed
-
Powertrain > Engine > Data List
Tester Display
Power Mode SW
Result
Result
Proceed to
Data List values are normal
A
Data List values are not normal
B
B INSPECT COMBINATION SWITCH ASSEMBLYClick here
REPLACE ECM
Replace the ECM.
Result
Proceed to
NEXT
INSPECT COMBINATION SWITCH ASSEMBLY
-
*a
Component without harness connected
(Sport Switch (Combination Switch Assembly))
Remove the SPORT switch (combination switch assembly).
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
8 - 3
Switch being pushed
Below 50 Ω
8 - 3
Switch not being pushed
10 kΩ or higher
Result
Proceed to
OK
NG
-
CHECK HARNESS AND CONNECTOR (COMBINATION SWITCH ASSEMBLY - BODY GROUND)
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
E136-3 - Body ground
Always
Below 1 Ω
Install the SPORT switch (combination switch assembly).
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR (COMBINATION SWITCH ASSEMBLY - BODY GROUND)
CHECK HARNESS AND CONNECTOR (COMBINATION SWITCH ASSEMBLY - ECM)
Disconnect the A173 ECM connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
A173-36 (PWMS) - Body ground
Switch being pushed
Below 50 Ω
A173-36 (PWMS) - Body ground
Switch not being pushed
10 kΩ or higher
Connect the A173 ECM connector.
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR (COMBINATION SWITCH ASSEMBLY - ECM)
REPLACE ECM
Replace the ECM.
Result
Proceed to
NEXT